O-ring Seal (ORS) Manifolds & Components

ORS Manifolds are a low weight, low cost system use Wilger’s full product line of O-ring seal components for any custom configurations needed.

Manifold Components

ORS manifolds are infinitely stackable, so they can be built into any required configuration.

O-ring seal (ORS) to ORS

An ORS male inlet with an ORS female port, allowing for an ORS metering orifice and ORS fitting to complete a manifold assembly.

ORS to Radialock Cap

An ORS male inlet with a radialock cap outlet (see Wilger Pricelist for options),  use with metering orifice (#40285-XX series) to complete a manifold assembly.

ORS Metering Orifices

O-ring seal metering orifices are accurate and large enough to make them easy to handle, so switching rates is easy.

Custom hole-size orifices and ISO-color coded orifices are available to match any rate required.

Compact & Durable

ORS manifolds are clean and compact. When you mount them to your equipment, they take up minimal space and can be used with Wilger mounting brackets on square tube framing.

360° Range of Motion

All O-ring sealed fittings can be spun 360° without fear of leaking of pulling out.

This makes installation easy as the fittings pivot to where you need them to point.

Chemical Resistance

All ORS fittings are made specifically for chemical resistance.

With all fittings made out of glass-reinforced polypropylene with VITON® O-ring options, there isn’t much that these manifolds can’t handle.